Thread: 1940 Ford Pickup

Tweet

Well here's what I did this week to the 40. I started measuring things and using a level and found out that the back 25 inches of the rails didn't line up height wise. The right side low lower by and inch than the left. Which ones right ? There really was noway to tell for sure. I put the boxing plate that I got from Welder Series in the right side and tacked it in place. Than heated the rail just past the plate and bent the rail up 1/2 inch , did the same on the other and bend it down 1/2 inch. Before I did the bending I traced a pattern off the left rail and compared it to the right and found that only the last 25 inches were out. When it was all cooled off everything measured up good. Sometimes I get lucky and it seems that today was one of them or at least till someone chimes in and tells me that I screwed up. Still have to weld the bushing to the frame for the shackle .




Also finished my cab mounting blocks

Originally Posted by Navy7797

Well here's what I did this week to the 40. I started measuring things and using a level and found out that the back 25 inches of the rails didn't line up height wise. The right side low lower by and inch than the left. Which ones right ? There really was noway to tell for sure. I put the boxing plate that I got from Welder Series in the right side and tacked it in place. Than heated the rail just past the plate and bent the rail up 1/2 inch , did the same on the other and bend it down 1/2 inch. Before I did the bending I traced a pattern off the left rail and compared it to the right and found that only the last 25 inches were out. When it was all cooled off everything measured up good. Sometimes I get lucky and it seems that today was one of them or at least till someone chimes in and tells me that I screwed up. Still have to weld the bushing to the frame for the shackle .

The shackle bushings are looking good, Navy!! Just curious if you measured your frame before or after you took out that last cross brace at the end of the frame...It doesn't appear that you welded any cross bracing on the rails so just wondering if the frame sprung a little when you broke that loose.......I'm just kinda thinking out loud here and you probably know this already, but most crossmember installation kits recommend tacking a crossbar to the rails before removing any crossmembers.
At any rate, sounds like you have it tweaked back into shape.

Originally Posted by randyr

The shackle bushings are looking good, Navy!! Just curious if you measured your frame before or after you took out that last cross brace at the end of the frame...It doesn't appear that you welded any cross bracing on the rails so just wondering if the frame sprung a little when you broke that loose.......I'm just kinda thinking out loud here and you probably know this already, but most crossmember installation kits recommend tacking a crossbar to the rails before removing any crossmembers.
At any rate, sounds like you have it tweaked back into shape.

Took lots of measurements before I removed the crossmembers.