Well here's what I did this week to the 40. I started measuring things and using a level and found out that the back 25 inches of the rails didn't line up height wise. The right side low lower by and inch than the left. Which ones right ? There really was noway to tell for sure. I put the boxing plate that I got from Welder Series in the right side and tacked it in place. Than heated the rail just past the plate and bent the rail up 1/2 inch , did the same on the other and bend it down 1/2 inch. Before I did the bending I traced a pattern off the left rail and compared it to the right and found that only the last 25 inches were out. When it was all cooled off everything measured up good. Sometimes I get lucky and it seems that today was one of them or at least till someone chimes in and tells me that I screwed up. Still have to weld the bushing to the frame for the shackle .
http://i990.photobucket.com/albums/a...psa91ebefe.jpg
http://i990.photobucket.com/albums/a...ps0d2ac593.jpg
http://i990.photobucket.com/albums/a...ps153ad89a.jpg
http://i990.photobucket.com/albums/a...ps35920b5a.jpg
Also finished my cab mounting blocks
http://i990.photobucket.com/albums/a...ps809a8b08.jpg