Pilot hole drilled for the passenger B-Pillar.....
http://i5.photobucket.com/albums/y16...5/IMG_3260.jpg
The center point is spring loaded, but they seem to locate better using a pilot hole vs. just a punch...
http://i5.photobucket.com/albums/y16...5/IMG_3261.jpg
http://i5.photobucket.com/albums/y16...5/IMG_3262.jpg
http://i5.photobucket.com/albums/y16...5/IMG_3263.jpg
http://i5.photobucket.com/albums/y16...5/IMG_3265.jpg
The plug weld holes drilled for the anchor and paint cleaned off in prep for welding..
http://i5.photobucket.com/albums/y16...5/IMG_3273.jpg
Apprentice E worked on smoothing off the plug welds from last week..
http://i5.photobucket.com/albums/y16...5/IMG_3266.jpg
http://i5.photobucket.com/albums/y16...5/IMG_3271.jpg
Welding in the anchor .....
http://i5.photobucket.com/albums/y16...6/IMG_3281.jpg
http://i5.photobucket.com/albums/y16...6/IMG_3283.jpg
For the lower anchor point, which will hold both the retractor and the lap belt, we used some 14 ga that will be plug welded to the back side of the inner quarter panel just behind the B Pillar.. A 1/2" lock nut is welded to the back side, and a spacer added to the front side to keep the lap belt off the side wall.
http://i5.photobucket.com/albums/y16...6/IMG_3297.jpg
http://i5.photobucket.com/albums/y16...6/IMG_3298.jpg
http://i5.photobucket.com/albums/y16...6/IMG_3284.jpg
http://i5.photobucket.com/albums/y16...6/IMG_3285.jpg
http://i5.photobucket.com/albums/y16...6/IMG_3287.jpg
Or the motion picture version....
https://www.youtube.com/watch?v=4na-...ature=youtu.be