Threaded View
-
01-23-2012 05:29 PM #1
Nextel/NASCAR sway bar selection
I set my 36 up for sway bars with splined ends and hid them in the spreader bar. I am absolutely baffled on material selection. I still havent found anyone with scales that I can borrow so I don't know the exact weight at each wheel. Should I wait until all is complete and weigh it, then order the correct material? Or can I just set it up with the lightest bar I have, 36.5"x1"x.095 wall with 14" arms and try it? How do these guys know the amount of weight needed at 5 degrees of turn at one wheel? Any guidance would be appreciated. I know I'm guessing at this time, but I was hoping to get myself in a ball park range so I don't have to make major changes on arm lengths and a-arm mounting points.
DavidDo not lift a rock only to drop it on your own foot
The Australians have finally discovered the origin of the word 'Vegan.' Apparently it's an old Aboriginal word for 'Bad Hunter.'
the Official CHR joke page duel