That'll come later!

I ran into another confusing step that deals with my fan. I have an aftermarket Spal fan that comes with all it's own wiring, it's pretty straight forward and has good directions. The problem is with the wiring kit, it has one wire that goes to the engine labeled "fan", under the dash is one "fan power" and another "fan fan". I would think the fan power goes to the kit on the ignition wire but I'm not sure, what do the other two do? I assume the one out to the engine is the power to the fan but I won't need that one as the kit has a heavier gauge power wire.

I could just cut all the fan wires out but I didn't want to start stacking a whole bunch of wires on the ignition switch.

I always run into these problems after EZ Wire is closed.


Thanks,

Sean