Thread: Wiring my Car

Tweet

Sounds good Dave, thanks.

It took me a couple of days to drill through my firewall but I finally did it. I got a threaded copper plumbing elbow from Home Depot and used it to run the wires through. It has another piece that threads on from the inside holding it in place. I fished the wires through to the front and clamped them in place.

Going to the rear I drilled a hole in the floor behind the door jamb and I had a lot of fuel hose left over so I ran the wire through a piece about 8 inches long and used that as a rubber gromet. I have to figure out where to tap off my brake switch, the tail section has 5 wires:

LT Park
RR Turn
LR Turn
Fuel Pump
Dome Light

Any ideas?? I would think it goes off the LT Park but then I wouldn't have any rear lights.

Sean