Thanks Bob, The dent puller was the screw type. The dent is at the bottom part of the door towards the back and runs through some of the contoured body lines if that helps?

Currently for tools I have a small wire welder, cutting torch with oxygen / acetylene tanks and a good air compressor that I inherited from my Dad. I have only used the wire welder to fix a broken bracket on a lawn mower deck (weld wasn’t pretty until I ground it down a bit but I think I got pretty good penetration) and the torch I played with enough to get that nice blue cone but I was not sure if the pressure was set right according to the gauges? If someone can help with what I should have the pressure set at I would appreciate that as well. I have not messed with metal work since Metal Shop in High School 18 plus years ago.

Back to the Dent Puller, would the wire welder I currently have be able to attach the studs for that type of Dent Puller?