Hey guys first hope all is well been working and tinkering some . Put the A on ebay and way low bids figure I wll get it going and then put it back on .



Well changed out the engine mount to the bar mount from Speedway . There mount holes where a inch shy at 16 and my SBF being 17 . 3 engines here and all measure out at 17 so its the bar that is off .

Set it deep and still have 8 inches to the oil pan and about 7 3/4 to the trans pan .


Before I cut it




Clearance after it was set in and tacked




Set down in the rails