1940 Ford Tudor Build Thread

[Dave Severson]

Yes I did Dave. Now the other issue that was brought to my attention. Look at the top pic in post 143...... The front part of the frame is above the rear part of the cross member by a good bit. Hopefully the LH rail is the same, or maybe that is a bad pic. I'm heading over there now to look at it. I think I know why it's hacked, I mean done like that...... Instead of notching the lower portion of the frame so the rack would fit, they raised the front of the frame to make clearance.

Yup, the front part of the frame is way too high, puts the spring tower up too high and the anti-dive angle for the upper A-Arm is way off!!!! Going to have to do something there, too. Missed seeing that when I looked at your pics.

Hopefully this pic comes through, it's the correct set up for anti-dive angle on the upper arm. The angle of the upper arm should be about 7-10 degrees with the front of the arm higher. As long as this angle is not less then your caster angle, it works out ok.