Thread: 27 T tudor Hot Rod build

Tweet

Well it has been too long since I kept this thread updated.

There has been some progress on the rod but not as much as I would have liked. I have been busy with finals in college and just finished up my
last ones this past monday. Another set back came in the way of finding the right diameter tubing for the rear shackles. I went to all the local
scrap metal shops with no luck. The work on the T came to a screeching halt for three days
until my dad found two pieces of tubing at my grandparents house that would work perfectly. Then locating the rearend commenced.

In one of my last post I mentioned I was going to a local swap meet to hope to find some hot rod parts. I found the 10.5" flywheel I have been
needing and I picked up my tires from coker. I had hopped to find more rod parts but there was none that I needed but there were some great
deals to be had on a lot of stuff I did not need.



And a couple more of the drivers side door getting final welds.