-
-
Nice rust repair and nice progress on your trans!
-
-
Nice work! It's getting closer with each panel!
-
-
Sheet metal in the floors are shaping up real nice .
-
I'm envious. I think I may be pulling the current frankenstien mess out and building a new one too!
-
Your trans tunnel turned out real nice!!
-
Thanks for the complements guys. I turned the cab over today and its not so nice looking under neath, LOTS of clean up work.
-
Navy watching this your 40 is so close to my 37 and when i have to redo it this can be my reference , great coverage .
.
-
More pic's of welded in panels, can't stand the open edges on the bottom so I welded them. Just a bit more and I'll sand blast the bottom and Paint it with bed liner stuff.
http://i990.photobucket.com/albums/a...ps5f7b70a0.jpg
More rust repair, weld grind weld grind.
http://i990.photobucket.com/albums/a...psd15de088.jpg
http://i990.photobucket.com/albums/a...psbc64fd91.jpg
-
Here's a few pic's of the exhaust and steering issues. It seems that I'll have to come off the exhaust header with a bend right away to give clearance for the steering shaft. How sharp of a bend can the exhaust pipe have ? I'm thinking I need a 45 degree bend with in an inch of the flange to get the clearance I'll need.
How Many steering knuckles can be used in the steering shaft assy. ??
In puts welcome.
http://i990.photobucket.com/albums/a...ps68f4fac0.jpg
http://i990.photobucket.com/albums/a...psc9f7d2eb.jpg
http://i990.photobucket.com/albums/a...psbc5dec68.jpg
http://i990.photobucket.com/albums/a...psc457aae6.jpg
-
Your 45 degree bend is not a problem. If you're making them up yourself a mandrel bent "U" or "J" on a nominal 6" radius will give you the bend you need, just cut the portion of the mandrel bend that you need and weld it into place.
On the steering u-joint question, you can have as many as you need, but you'll need to add rigid intermediate supports when you go more than two. A universal at the column end and a second one at the steering box with a solid shaft between is stable and common. If you need a third universal in between then you have to add a fixed support on one side of that third joint.
-
rspears: Thanks for the feed back. I have 2 Heim joints to support the steering if needed. So many things are having to be worked out at once just to move forward a little bit. I'm also wanting to get the motor fired up for the 1st time, been sitting in my shop for 2 months all wrapped up in a blanket just waiting.
Any in put for Mufflers ? Looking a FlowMaster but that's taxing my budget. Thanks again for the in put.
-
Sometimes you can luck out and find decent exhaust/mufflers, etc on craigslist. I think this is in your area: 2 New Flowmaster Mufflers