No picture, it is back on the jeep.......got the needles back in.......they are straight out the front...the holes I am talking about are at a 45 degree angle to that pointing right at the mounting bolts. same level as the needles ...they are small holes, maybe a little under a 1/8th inch....a little bigger than a 1/16th.

I am going to try a few things...it has a vac point going to the distributor that comes off right at the side of the bowl....might plug that and go straight vac to the base plate for the distributor....also will be plugging the distributor line to see if the vac advance canister is shot......that would cause a lean condition and hesitation too...I think.

You can see the vac line in my pics.......does not seem like a normal place for straght vac to come from.....might be some sort of ported vac emissions garbage port.