P1010013.JPGP1010014.JPG


This is the end result....better than it was and internally like new......this one will be covered by a huge breather anyway....I admit it was hard to resist polishing the aluminum out though.....

Now just have to drill and heat,spray and cuss and easy out the bolt from the intake carb mounting pad and I can see if it was a sucessful rebuild.


Then bend up a new fuel line from the pump...some one cut the metal one and inserted a fuel filter between the pump and carb........I will put it back in the fuel line just after the tank mounted to the frame.....I do not trust unknow rubber hose,a clear plastic fuel filter and hose clamps under the hood where if it leaks or fails fire is a sure result ...