Thread: Using Edelebrock carbs on blown 350

Tweet

Going for the rustic look Huh, Donie.
Kurt

Originally Posted by vara4

Going for the rustic look Huh, Donie.
Kurt

Actually, yes, in the sense of non chrome..polished stuff to a minimum.. sand blasted the polished scoop, not sure where the piece of pink anodized linkage came from...Ron Upham I think....need to paint it....D

Hello.... thanks to all for the feed back on using Ed's carbs on 350 blower engine... i'm think'nn there going to be a easy dial in compared to Holley carbs
And a tad more street use friendly then Holleys.

Regards Daryl

Replaced my 6oo dbl pump holleys with 500 Edl to tune it down-made it even quicker. Motor came out of a 10:90 car-put it in a 1800lb 29-got rid of it fast!

I have been running my tunnel ram set up for 4 years and it runs perfect. All I did was adjust the air/fuel ratio with a vacuum gauge. Plugs look great and it runs perfect!

Also, Big Al's Toy Box, specializes in blower motors. They use Holley or Edelbrock All they do is re-jet them for the blower and they run great.