Thread: Using Edelebrock carbs on blown 350

Tweet

Originally Posted by vara4

Going for the rustic look Huh, Donie.
Kurt

Actually, yes, in the sense of non chrome..polished stuff to a minimum.. sand blasted the polished scoop, not sure where the piece of pink anodized linkage came from...Ron Upham I think....need to paint it....D

Hello.... thanks to all for the feed back on using Ed's carbs on 350 blower engine... i'm think'nn there going to be a easy dial in compared to Holley carbs
And a tad more street use friendly then Holleys.

Regards Daryl

Replaced my 6oo dbl pump holleys with 500 Edl to tune it down-made it even quicker. Motor came out of a 10:90 car-put it in a 1800lb 29-got rid of it fast!

I have been running my tunnel ram set up for 4 years and it runs perfect. All I did was adjust the air/fuel ratio with a vacuum gauge. Plugs look great and it runs perfect!

Also, Big Al's Toy Box, specializes in blower motors. They use Holley or Edelbrock All they do is re-jet them for the blower and they run great.