Welcome to Club Hot Rod!  The premier site for everything to do with Hot Rod, Customs, Low Riders, Rat Rods, and more. 

  •  » Members from all over the US and the world!
  •  » Help from all over the world for your questions
  •  » Build logs for you and all members
  •  » Blogs
  •  » Image Gallery
  •  » Many thousands of members and hundreds of thousands of posts! 

YES! I want to register an account for free right now!  p.s.: For registered members this ad will NOT show


All Blog Entries

  1. What's on your bench

    by on 01-31-2017 at 02:47 PM (2017 Hot Rod Power Tour)
    Quote Originally Posted by 53 Chevy5 View Post
    Now if it was asked, What is on your Camaro? I think I would win the prize
    Tags: sweet Add / Edit Tags
  2. ignition problems

    by on 08-04-2015 at 05:04 PM
    Quote Originally Posted by rspears View Post
    Joe, what type of compound are you using between the module and the mounting surface on the distributor?
    I was using a dieletic grease.. did some research and found a silicone based heat sink paste that I am going to try....Not going to give up the fight..
  3. ignition problems

    by on 07-27-2015 at 09:29 PM
    Quote Originally Posted by papajoe49 View Post
    hey guys its papajoe again. Put a new alternator in and have 14.5 volts going to the battery.took it for a run and it ran great ran it for about a half hour volt meter said 14.5 volts. Started it uo tonight and it fired right off. Went for a drive about 15 minutes into it slowly shut down started coughing and quit don't know where to go put a brand new module in yesterday...Take any help I can get. its a 350sb mild cam bare bones..DUI dist. New everything..Cant seem to get a handle on it!!!!!
  4. Charcoal Paint

    on 03-21-2015 at 10:06 AM
    Quote Originally Posted by F-V View Post
    Finally got to put the van in a solid colour be it Carbon black!
    Attachment 63242
    Attachment 63241
  5. Turbocharger part wanted

    by on 02-28-2015 at 05:18 AM
    I am looking for a cast aluminum turbocharger manifold. I have seen the manifold before but I do not know who makes it.
    It is a 2 plane manifold with holley square bore flange on top and bottom.
    The holley carb mounts on the top chamber with hose connection to the
    turbo intake. The lower chamber accepts the pull thru turbo output. This manifold mounts on any holley square bore manifold placing the carburetor
    above the stock position.

    This is similar ...
Page 3 of 4 FirstFirst 1 2 3 4 LastLast
Links monetized by VigLink