Thread: How far will front driveshaft yoke slide into turbo 350 tailstock?

Tweet

This is an identical front yoke to the one installed---as you can see, the machined surface goes right up to the shoulder, and the internal spline runs another 1/2" past the shoulder on the inside. My trusty tape measure tells me that it is 3 13/16" from the shoulder to the end of the machined surface. Once I get some clear insight into what is actually going on, if my drive shaft is 1/2" too long, I have no reservations about cutting 1/2" off the end of the machined yoke with the air cut-off diamond wheel to give myself the needed clearance.