Right now i am doing a 67 ford F100. its sitting in my shop down to the frame. i am about to throw disk breaks on the front end and then do a full 2 inch drop on it. for drive train i am getting a 390 built for it. i got the build sheet back for it the other day and it'll be around the 400 hp. so nothing to crazy. behind that i have a C6 that i am getting a buddy to go through and check it out for anything wrong with it. ive got a 9 inch rear end to finish it off. the body is going to be half stock on it. no chop or anything planed quite yet. i am going to put a cowl hood on it and a phantom grille. on the back end i am going to flaten out the tail gate and do somthing with the tail lights. put a roll pan on to clean it up a bit. then finish it off with a set of 4 inch megaphones. for rims im planing on having just some american racing 20 inchers on it. i know that this doesnt seem to great to some of you guys out there that are big into the industry. but this is going to be my first vehicle as i am only 15 years of age. so i figure that this was the only way to do it and im hoping that it will be a good daily driver. Kris