Well This is what I did. I used two welding clamps to hold the inner frame from moving all that much. Then used a 36" tire iron and put the rounded tip in the center of the dent and pushed againest it. While pressure was applied I used the hammer to tap around the outside. The crease is slowly comming back up. Not finished with it, but I have time. There was also alot of deep dents in the door that was covered with bondo, and sprayed some kind of yellow primer. I ground out the bondo and used the clamp method. They kind of poped out as well. I did get a couple of oil cans, but I heated up the tip of the oil can to near red hot. Because it came out a little more I hammered with a dolly behind it to flaten it out. Then I quenched it and the oil can was gone. Thanks guys. I just have to take my time. Maybe by the end of the Summer I might have it all in primer..