Thread: New Finned Valve Covers HELP!
Results 1 to 8 of 8
LinkBack URL
About LinkBacksHybrid View
-
02-06-2008 01:35 PM #1
CHR Member
- Join Date
- Apr 2006
- Location
- Rochester
- Car Year, Make, Model: 1930 Model A
- Posts
- 101
Bob...here is the URL for the covers I purchased. Is there a rubber grommet that large to cover the hole and reduce down to the size of a pcv valve?
eBay Motors: Edelbrock Small Block Chevy Vaulve Covers (item 130189638075 end time Jan-22-08 21:10:15 PST)
-
02-06-2008 03:11 PM #2
CHR Member
- Join Date
- Apr 2001
- Location
- Salado
- Car Year, Make, Model: 32, 40 Fords,
- Posts
- 10,898
Took a while to find, but here's the one I've used; Holley Performance Products Ford Valve Cover Service Part Grommet*241-215Your Uncle Bob, Senior Geezer Curmudgeon
It's much easier to promise someone a "free" ride on the wagon than to urge them to pull it.
Luck occurs when preparation and opportunity converge.
-
02-06-2008 03:15 PM #3
CHR Member
- Join Date
- May 2004
- Location
- so.cal
- Car Year, Make, Model: 66 c 10 fleetside longbed
- Posts
- 1,942
Then just use the other breather for a fill.......
""No no holes drilled"" ,they make a fitting to use the oil fill on one side as the pvc also ,just cant find the link........,but what Bob posted will work fine ,just use the best one for oil fill and the obstructed one for the grommet and pvc.
One will be pass front /the other ,drivers rear.
I just looked at the pic you posted ,there would be no problem drilling on that flat area ,since its already there either............if it made install and routing look better and was simpler to use.....you definatly have options with those covers.Last edited by shawnlee28; 02-06-2008 at 03:19 PM.
Its gunna take longer than u thought and its gunna cost more too(plan ahead!)
Reply With Quote
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Either return this forum to what was or get the HELL OUT!
Dead!