Thread: B&M shifter problems

Tweet

don it is the pro rachet model, when i first installed this shifter it shifted hard, the linkage arm i installed was rubbing the oblong oversized washer that is attached to the shifter rod coming out of the tranny. so i loosened the arm i installed and slid the arm further on the rod and freed it up. maybe that is your problem. well being a typical man i could not wait any longer and took a small hammer and punch to the obstruction. one very small tap and it dislodged the fragment. it apears to be a pressed in pin,stud, of some sort. if you look at one of the photos the smaller end seems to be almost hollow. dont be fooled by the picture. it is not much bigger than a pencil lead. now i just need to figure where it came from. it seems to shift fine but the peice came from the shifter, my car is too clean and the shifter is covered, for it to have came from anywhere else.