Search:
Type: Posts; User: brand_x_racing
-
05-08-2007 09:00 AM
Thread: Was running good
by brand_x_racing- Replies
- 19
- Views
- 3,321
ok
got the carb done last night, on the older holleys the acc. pump goes through the metering block into the main body with a brass shaft with o-rings on the end, the o rings were bad leaking fuel into...
-
05-07-2007 02:19 PM
Thread: Was running good
by brand_x_racing- Replies
- 19
- Views
- 3,321
Ok, see how this goes
I will open her up tonight and let yall know tomorrow what I find thanks yall ,gives me some direction here, I will post my results either tonight or tomorrow. Thanks again!
-
05-07-2007 08:24 AM
Thread: Was running good
by brand_x_racing- Replies
- 19
- Views
- 3,321
huh
Well when its higher rpm like 2500 holding it there it stabilizes pretty good, then when you let off it snaps up real quick then recovers pretty quick too,, the valves may be a problem and it was a...
-
05-07-2007 07:02 AM
Thread: Was running good
by brand_x_racing- Replies
- 19
- Views
- 3,321
metering block
I have gone through them, cleaned, there are all composit gaskets now, I will pull it apart tonight check it all again, see whats the real problem, and the vac. gauge was very quick on its movement...
-
05-07-2007 06:57 AM
Thread: Was running good
by brand_x_racing- Replies
- 19
- Views
- 3,321
carb adj.
The carb is 650 cfm holley single feed vac. secondaries, I have the electric choke, all is set open no choke working on it, it is not hung on or binding, the floats have been set and checked, new...
-
05-07-2007 05:58 AM
Thread: Was running good
by brand_x_racing- Replies
- 19
- Views
- 3,321
Was running good
Here is a good one, 77 chevy k-10 pickup 4wd. 350 4bolt, mild rv cam was smooth idle. I have a performer intake with a 650 vac, sec. carb. Ok, built this motor in december got it running had...
well I decided to do another mod to gain max travel of bars past the intended travel points just for that peace of mind. 1/8 inch is to close so now I'll have 1/2" or better. I cut a 3/16" wall...
New Project