Thread: I'm a new user from San Francisco looking for some advicee

Tweet

One thing to keep in mind is that the "rat rod", or traditional rod, or nostalgia rod craze (whichever term you like) that's going on right now has run up the price of the older hydraulic drum brake set-ups for these. And the competition is fairly heavy. Still, if you're a good hustler you might find something out there low buck...........just gonna have to work hard at it. Some look at the prices of drum and say, just go disc in front, it's near the same money. Your call.

The '39 to '48 brakes Don mentioned work better than your mechanicals, but are tough for most people to adjust where they work real well. It's an experience thing. Also they are not self energizing so require heavy pedal pressure for rapid (relatively) stops. Sets sell on ebay and places like Fordbarn and Craigslist for several hundred dollars, and then will often need some rebuilding. If you buy the drums blind they may be worn beyond safe use, and new replacements run about $150-200 each.

There is a better alternative that will give you self energizing drum brakes, but it costs. The brake of choice (drums f&r) is what's called the Lincoln brakes. If you do a Google search for "Reproduction Lincoln Brakes" you'll see several vendors. Here's just one example; http://www.est1946.com/index.asp?Pag...ROD&ProdID=822 If you use the drop down at mid page you'll see the rear set too. With shipping you're close to a grand, but it's new hardware.

You can build something like these if you can locate some good early '50's (up to '56) F2/F250 Ford truck backing plates. I can give you the part numbers for the shoes and cylinders if you choose to go this way and find some. Again, a lot of guys know about this and the demand is competitive. Bare backing plates can easily go over $100 a pair, and will likely need some repair. Add the cost of shoes and cylinders and $300 is easy to hit, per axle. Some guys are selling this type of set-up on ebay and Ford barn, and depending on the bidding/asking they go for $3-400. If you go this route and use stock early Ford drums you need 1 3/4" wide shoes, not the 2" ones the Buick drum guys use on the same backing plates.

Another alternative is the '53-56 Ford F100 front brakes (you still have to use any of the above for the rears). You'll need the backing plates, loaded, plus the hubs and drums. These are a 11" diameter drum rather than the aboves which are all 12". These have the advantage of maintaining the 5 1/2" bolt circle for your exising wheels.

Get a pedal assembly from a '39 which will bolt right in to help mount the master cylinder, and the clutch linkage lines right up. Or you can get a '40 pedal assy which will take a little mod for the clutch linkage. To this you can bolt a stock, single chamber m/c, repops are readily available, or better yet, a '67-8 Mustang dual chamber m/c for drum brakes (need an adapter for mounting bolt differences, readily available from most hot rod vendors). The plumbing is standard tubing and hoses.

As for the electrical, Don's info will work as long as your wiring is good, and not deteriorated. 6v wire is larger gauge than 12. Here's a quick article; http://www.patricksantiquecars.com/articles.htm

The Runtz resistor is good at each gauge where appropriate, those can be bought from Patrick's, or Speedway; http://www.speedwaymotors.com/xq/asp...qx/Product.htm