Denny--I'm gettin old, and kinda stoopid---but---It seems to me that somewhere in the last year, I seen a thread either here or else over on the HAMB where somebody was complaining about exactly the same thing---the cups on an aftermarket headlight bar being rotated incorrectly. It could be that all the bars Gennie Shifter makes are "out" by a few degrees, but one thing for Damn sure---theyr'e never going to admit it. They even put a disclaimer in the instructions which basically says---if our headlight bar doesn't fit your car, it could be caused by distortion from boxing your frame, fender support brackets installed incorrectly, manufacturing tolerances, Blah, Blah, Blah----our bar is made to original Ford specs in the mounting flange area--Don't come whining to us!!! Still---the bar is a beautifull peice of work, and its not so far out that its a disaster. If I can bring this off without having to repaint my front fenders, I'm going to be happier than a pig in mud!!! I don't mind having to do a little creative trimming on the headlight pots, Hell, I don't even mind if I've got to whittle out a couple of tapered shims from stainless to get a perfect fit bertween the flange on the bar and my fenders. Its going to look beautifull, and as someone else on the board said (I think it was Don shillady)---There really isn't any such thing as a "bolt on and walk away" aftermarket hotrod part.---Right!!!