Thread: 472 into the monte sensors

Tweet

Barb, the oil pressure sender goes in the back of the block about centered below the intake manifold (the hole in the block is 1/8" pipe if I remember correctly).

There should be a threaded hole in the drivers side head a little to the right of the distributer that can be used for the temp sender with the appropriate size bushing.

You will need to use the Monte senders for the guages to work properly.

The Tach signal wire will go to the distributer side of the coil if your running points or the tach terminal on the distributor if you have HEI.

By the way Hoss the Caddy intake is dry (no coolant flows thru it).