Spent the entire day moving the lower hinge on the passenger door, as well as capping off the lower section of the door.

First, I had to modify the mounting pad to angle the hinge

[IMG]20160915_093612 by Ben Modified, on Flickr[/IMG]

Cut a piece of 3/16" flat bar to weld to the new mount area. Tapped the holes to accept the stock screws.

[IMG]20160915_150019 by Ben Modified, on Flickr[/IMG]

Then trim up the door to accept the original hinge mount section from the further down door.

[IMG]20160915_102203 by Ben Modified, on Flickr[/IMG]

The hinge is in place

[IMG]20160915_150033 by Ben Modified, on Flickr[/IMG]

Cut out a piece of metal to cap off the bottom of the door

[IMG]20160915_154705 by Ben Modified, on Flickr[/IMG]

Welded in along with a piece of small round bar to give it a blunt edge

[IMG]20160915_171104 by Ben Modified, on Flickr[/IMG]

Just need to finish off the bottom of the nose where it meets the door and fab a channel on the inside of the door to accept weather strip along the bottom

[IMG]20160915_173703 by Ben Modified, on Flickr[/IMG]

[IMG]20160915_173914 by Ben Modified, on Flickr[/IMG]

http://www.BenModified.com