Thread: 55 Wagon Progress
Threaded View
-
01-10-2013 07:27 PM #1
55 Wagon Progress
This is a customer car, the owner and I discussed shaving the fender seams quite a while back, and she asked about it again last week, so I guess we're on the hook..
The bolting plates are cut out of the way, and the folded flange is trimmed, leaving a bit of extra to allow for fine tuning the weld joint.
Bottom of the fender is cut loose from the bolting plate using the cutoff wheel. Then sanding the face of the fender leaves a contrast at the bend of the flange for a good guide for trimming with snips....
Planishing out the fold to fill the gap....
Clamps used to test fit. Still needs some fine tuning for zero gaps, but we'll finish that another day..
Robert
The last couple of weeks have been spent waiting on parts and getting the engine ready to put in the car. I found a manifold (turned out the guy I bought the center sump oil pan from had one). It’s...
1968 Plymouth Valiant 1st Gen HEMI