Finishing up on the radio holes...
http://i5.photobucket.com/albums/y16...ure%202565.jpg
http://i5.photobucket.com/albums/y16...ure%202564.jpg
http://i5.photobucket.com/albums/y16...ure%202583.jpg
Shaving the other seam, here bumping the panels to get a consistent height across the front...
http://i5.photobucket.com/albums/y16...ure%202572.jpg
The upper section would prove to need a bit more persuasion...
http://i5.photobucket.com/albums/y16...ure%202573.jpg
Tool modification...
http://i5.photobucket.com/albums/y16...ure%202575.jpg
A chunk of 3/4 square stock laid in dash void to use as fulcrum...
http://i5.photobucket.com/albums/y16...ure%202576.jpg
Heat applied...
http://i5.photobucket.com/albums/y16...ure%202574.jpg
http://i5.photobucket.com/albums/y16...ure%202577.jpg
Results... before..
http://i5.photobucket.com/albums/y16...ure%202573.jpg
After...
http://i5.photobucket.com/albums/y16...ure%202578.jpg
http://i5.photobucket.com/albums/y16...ure%202579.jpg
http://i5.photobucket.com/albums/y16...ure%202582.jpg
http://i5.photobucket.com/albums/y16...ure%202584.jpg
This view from the back side of weld dot penetration shows Kyle has pretty good consistency in weld dot sizing.
http://i5.photobucket.com/albums/y16...ure%202566.jpg