Thread: 55 Wagon Progress
Results 331 to 345 of 1825
Threaded View
-
01-10-2013 07:27 PM #1
55 Wagon Progress
This is a customer car, the owner and I discussed shaving the fender seams quite a while back, and she asked about it again last week, so I guess we're on the hook..
The bolting plates are cut out of the way, and the folded flange is trimmed, leaving a bit of extra to allow for fine tuning the weld joint.
Bottom of the fender is cut loose from the bolting plate using the cutoff wheel. Then sanding the face of the fender leaves a contrast at the bend of the flange for a good guide for trimming with snips....
Planishing out the fold to fill the gap....
Clamps used to test fit. Still needs some fine tuning for zero gaps, but we'll finish that another day..
Robert
Tom had been in the liquor business for 25 years. Finally sick of the stress he quits his job and buys 50 acres of land in Alaska as far from humanity as possible He sees the postman once a week and...
the Official CHR joke page duel