Thread: 55 Wagon Progress
Threaded View
-
01-10-2013 07:27 PM #1
55 Wagon Progress
This is a customer car, the owner and I discussed shaving the fender seams quite a while back, and she asked about it again last week, so I guess we're on the hook..
The bolting plates are cut out of the way, and the folded flange is trimmed, leaving a bit of extra to allow for fine tuning the weld joint.
Bottom of the fender is cut loose from the bolting plate using the cutoff wheel. Then sanding the face of the fender leaves a contrast at the bend of the flange for a good guide for trimming with snips....
Planishing out the fold to fill the gap....
Clamps used to test fit. Still needs some fine tuning for zero gaps, but we'll finish that another day..
Robert
I won't agree or disagree on your opinion of comp cams, but when I put a new cam in the 350 in my 76 Vette I went with Howard's and have not been disappointed. With the junk coming out of China these...
New guy from Utah.