Same here woth 460 cubic inch v8 in a 48 ford truck, you'd think that huge old front end would hold more ! :)
Printable View
Same here woth 460 cubic inch v8 in a 48 ford truck, you'd think that huge old front end would hold more ! :)
Crikey!
I don't envy you the task of making it all fit; it looks like you've gutted a goose and thrown the entrails at it . . . what a maze of pipes and hoses!
Rather you than me mate; but having seen what you've achieved so far I'm sure you'll work it all out.
Love it when you say that, Johnboy!!! I almost used it in a post myself the other day but I couldn't remember if it started with a "C" or "K"!!:LOL::LOL::LOL:
I'm not exactly sure what the real definition is but I can think of several words it can substitute for!:eek::LOL:
Sorry Falcon! Now back to the amazing work on your "MoFo"!;)
Randy, I think I've called it a MOFO more than once in the past few weeks!:LOL: Lots done in the past few days; I found a belt that fit and got the tensioner mounted, intake is mounted along with all the little gizmos bolted to it and hooked up. That stuff sure eats a lot of time. I found an adapter to eliminate the factory oil cooler and mount a take off plate so it's on the way and the cooling passages for the factory one are plugged.
You're doing a fantastic job on this beast, Falcon! I predict lots of head scratchin' when you pop the hood and the crowd at the car shows try to figure out what engine you're running.
I predict lots of head scratching when I try to START it and figure out why it won't run!:LOL:
Falcon great job! It sure is coming along nicely!
Thanks, Ryan. I've been sick for three days so I didnt get back out there until today. I got the O2 sensors put in and had to shorten the harness for the passenger side one. I made it way to long, not sure how I measured that wrong. I put the core support on and made a mount for the oil cooler (Caprice police car) and the remote filter. I'll have to get a 90 degree elbow to shoot the air intake sideways so the radiator will fit. Looks like a late 60s Mustang aluminum radiator is going to be the best fit. The passenger side wheel well still fits but the drivers side will need some surgery.
I also picked up a new parts hauler yesterday; it's a 2000 3/4 ton Ram van with a 5.9. A little bit of a beater but it runs great, everything works, and has lots of hauling room. Best of all, it was cheap.
Shaping up Falcon! Oil cooler looks to be a heavy duty unit and the van should be up to hauling most anything!!!!
Great work and thanks for the tip on the cooler. That should make for a cheap cooler in yards.
$10 special, Ryan. Plus it's probably made way better that the aftermarket ones.
I got all the cooler and filter lines run tonight; hope to get radiator in and maybe fuel lines run this weekend.
Lots done today; got my radiator installed, starter back in, ran the battery cables for the trunk mounted battery, did some work on the panel where the ECC and relays are going to be mounted, and notched the steering column tube to clear the drivers side header. I raised the engine 1/2" but still had to notch it; forgot to account for the thickness of the header wrap when I built the header tube around the column. Im going to have to relocate the MAF; it's hitting the top of the radiator fan and I've got the radiator as far forward as it can go and the fan as low as it can go. But all in all; it's coming along pretty good. Im hoping there's an attempt at starting the engine in the near future!
Another day closer. There seems to always be something that doesn't fit first time out of the box
Progress at any rate is still progress!!!! Nice work, Falcon!