Thread: 49 More-door build

Tweet

Ok, the head is on and the clutch linkage is squared away. The shift linkage was a nightmare. No matter how I adjusted it it would not hit all the gears. Finally after looking at the other trans several times I found that the upper shift arm was 3/4" longer than on the trans I put in the car. Taking this arm off while the trans is in the car is tough; you can just get three fingers and a wrench in between the floorboard and the nut that holds on the arm. Flipping the wrench gives you about 1/4 turn per flip. But after swapping it, all gears are where they should be. On another note my super slick homebuilt master cylinder bracket ended up right where one of the shift rods needed to be so I have to do some alterations if I want brakes AND gears. Also, I really don't like the look of the stock tail lights so I'm going with these. There from a 59 Catalina and are a little big but I like them.