Well I figured out I can MIG Stainless. So I decided that since the headers are stainless I bought some stainless dump tubes, a couple of bends and 5' of pipe and today I built the exhaust from header to just behind trans cross member, where mufflers will go. Driver side dump tube is slightly further back than pass side. Yup you guessed it. I built pass side first, and forgot about that danged pitman arm. But they are pretty close and with the pitman arm there unless you get a tape you cant tell moving from side to side.

DSCF3685-600.jpg

DSCF3686-600.jpg

DSCF3687-600.jpg