I'm running a mechanical fan, and it was really tight between the radiator hoses. So I made a pattern of the blade end, and trimmed each blade 3/4" and worked over a piece of 3" pipe to get the little flare back on the blade ends.

DSCF3680-600.jpg

I didn't like the look of the round pedal pad I had, so I made one out of some 3/8" thick aluminum and drilled and beveled some speed holes in the new one. You also can see I made the removable panels that finish the floors in the corners. I even found a washer hose that is perfect to cover the double u-joint and will give this a nice finished look.

DSCF3678-600.jpg

After much pondering.......... I tossed most of the bench seat that I had from a mini van. It just wasn't working. The way the back was made it was almost impossible to thin. So what I ended up doing was to strip the seat. Throw the back in the trash, and use only the bottom of the lower frame. Just the perimeter tubing and springs, and foam. I made some rails for the lower cushion to sit on, and be able to remove for access to under seat storage. And then just made a back from some 1/2" cabinet ply and covered in foam. The upholstery is just some old junk I had, just to get a visual and see how it sits. It's perfect. I do believe now I will extend the steering column about 2 1/2" though.

DSCF3681-600.jpg

DSCF3682-600.jpg