Thread: quicksteel rather than weld?

Tweet

cant you get some one to weld it or you could solder it or braze it or you can punch a hole in the pan this will roll some metal in the hole then tap with a pipe tap if you do this rigth you can get 3 threds to hang it on to then wash with thinner and use you j b putty if you have a fule pump plate on it take it drill and tap it for your return . oil when hot leaks any were i would not trust it to do all of the job . what we did was use AN bulk head fittings in the pan this is a good way to go if you do not want to weld but you have to pull the pan i would not be to hot on drilling a pan and worry about the crap/steel in the pan when done .YOU SHOULD PULL IT DO do it right