Thread: What fuel injection control should be used?

Tweet

Thanks Roger. I think the retro controller from fast appears good.
Lets open the new bag of parts a little futher. I like magnuson superchargers and the fact they are more efficient than the normal roots blowers. I had a thread looking at the M112 blower on a SBC and liked the torque results. Eaton replaced the M112 with a M122 on the Ford Gt500 Mustang motors. The M122 was a newer design with lower temp outputs and better efficientcy. Lots of Gt500 owners upgraded their superchargers at delivery to even better units creating a market for the M122 blowers. I purchased a M122 with basically no miles and would like to place it on the SBC. I think I would like to use an intercooler since I wish to retain the current 9.5 compression ratio. Looking at the Fast unit, it appears they
can control the Ford throttle body. I would like to build an adapter setup to bring this all together. Also going to use the 195 profiler heads that Tech suggested. Possible long road full of lots of mistakes but hope to create super torque at the street RPMs.

I think this is like asking if a Ford is better than a Chevy-you will get all sorts of opinions.
I am a big Holley EFI fan (probably because I am using one), and I did a LOT of analyzing before I bought one-none of these Systems are what I would call "cheap"-

My reasoning has more to do with the ease of use, available support (Holley expects that whoever you purchase their product from to provide Technical/Start up support-that was big for me), and, there are remote Tuners available to help (I think there are also remote tuners available for FAST too)-the fact that Holley offers a few different ECU's (read cheaper/fewer inputs/outputs) gives you a choice-

I chose the Dominator due to the fact that I am running a 4L80E and needed something to control my electronic Transmission (you can't do that with an HP)-to do the same with the FAST, you have to run a piggyback, although I believe they will (and are) catching up-its' all in one Box with the Holley-

Also the Dominator offers a LOT of inputs/outputs-I didn't think that was a big deal at first, then I realized that (for instance) I could do away with an electric Fan controller (you can set the Dominator to turn on/off the Fan at whatever Temp you choose), and, I am running things like my paddle shifter through it, along with an engine shut-off if the Oil Pressure/Coolant Temperature go over limits that I set (and lots more)-you will find all sorts of reasons to use them-

I would look hard at the Holley HP-it's definitely cheaper, and if you don't need as many inputs/outputs (think hard!), or need to control an electronic Transmission, it could save you a reasonable amount-

Thanks for this thread,

I am limited in funds and was interested in the FITech $795 unit which has no spark sync. I suppose it is a constant-spray device? My "impression" is that the unit can be added to an existing intake without drilling & tapping for nozzle ports? It seems to me that this is a very crude setup but I recall a dragster built on the cheap with two Model A four bangers that used a windshield spray unit for a fuel injection setup. Probably that can only be used for wide open runs so is there any experience with this new low buck FITech unit? The real reason I am interested is that the FITech tech person estimated an improvement of 5-7 mpg. My original goal for a mild SBC wth an OD trans and 3.55 rear was 20 mpg but really I only get 16 mpg so maybe this simple unit could push my mpg over 20. What about "drivability" and idle?

Don Shillady
Retired Scientist/teen rodder