Thread: Decking questions for Pat

Tweet

i have to think some about this but if you .032 off the deck the intake could be sucking or any rocker mounting points not sealed going in to the intake port. as for the rings i have used many plasma molly rings they seal up .what do you have for valve seals . sure the rings are facing the right way was the block honed with deck plates ? were do you have the pcv valve hook in to ? what are you using for breathers ? i would never use a PVC on a blower engine or any thing much over mild build

Valve seals are viton and brand new set up buy engine shop. Rings are installed correctly as I read the directions 100 times over. The block was honed with deck plates and squared to crank CL. I am going to omit the PCV valve altogether. Before I tore it down it was going through oil like mad. Thought we fixed that prob. The blower was completely soaked and had standing oil in the intake runners. As block came out of a sprint car one of the screens was plugged with epoxy not letting the one bank drain back. Thought it was allowing the PCV to suck the oil out.

Rocker stud bores do not go all the way through into the intakes if I remember right.

Keith