Thread: For the CHR "steering committee"

Tweet

This is all the cam I'd use in that motor with the SCR at 9.77. It's ground on 110 LDA and closes the intake at 36 ABDC for a DCR of 8.5......be sure to build the motor with a squish of 0.035" to 0.040" so it will run on pump gas. Juggle the deck height with the gasket thickness to get there. I like the KB hypers because of the way the dish is offset on them. The crown provides an excellent mating surface with the flat underside of the head for a good squish pad. Use 1.6 rockers on both intake and exhaust if you want, for a valve lift of 0.498".

http://www.cranecams.com/?show=brows...tType=camshaft