Quote Originally Posted by 34_40 View Post
You are correct. The door panel is just 3/32 maybe an 1/8" above the door bottom. You should see a small lip on the rubber seal that fits into the door panel and the remainder of the seal top goes up behind the panel. The top should have equally spaced holes where the clips would've gone.
At the front of the door I trimmed it at an angle to give clearance as the door closes.
That makes sense. Thanks for the good explaination. My interior door panels are flush, or maybe even a bit below the actual door bottom, and that's causing a problem. I think I'm going to have to peel back my vinyl and trim the bottom about 1/4". That may make this seal a "round tuit" project, as in "When I get around to it." I appreciate the insight, Mike.