Thread: S10 T5 to early bellhousing

Tweet

You haven't ever cut splines on an shaft or axle have you????????


Use the spacer-----------


Mike, I'm sorry if the multiply question marks and dashes upset you as it has just been pointed out in a PM to me that its bad internet ettique and manners to do that. I have a problem with the tendons in my right arm/hand and I have a tendency to linger with my finger a millisecond on the last key and I get multiples.


If it was just an issue of machining off some of the splines it would be simple to do but adding length to them is pretty much an insanely difficult thing to do.


The spacer you need ( haven't used one for 7 or 8 years) used to be about $70 but much more now. Pretty straight forward to make one with a couple machines--you'll need a piece of inch thick alum plate and cut a recess for the trans to center on back side plus an out cropping on the forward side to center in bell hole