Thread: manual shift VB
Threaded View
-
11-29-2009 07:57 AM #1
manual shift VB
got the manual shift valve body for my thm350, In the instructions i remove the inter mediate servo piston assembly and discard. then plug the hole for the apply shaft. also i plug the 2nd gear accumulator passage.
Sounds like the band becomes a piece of flotsam, i am rebuilding the trans can i just leave the band out? I sure do not like the idea of it just rattling around in there.
Moving on to next phase of frame reconstruction . Due to the Trans location I need to build a new center section for the X member. 1st cuts have been made . [/URL] I will use this 6"dia. ...
New Project