Thread: manual shift VB
Hybrid View
-
11-29-2009 07:57 AM #1
manual shift VB
got the manual shift valve body for my thm350, In the instructions i remove the inter mediate servo piston assembly and discard. then plug the hole for the apply shaft. also i plug the 2nd gear accumulator passage.
Sounds like the band becomes a piece of flotsam, i am rebuilding the trans can i just leave the band out? I sure do not like the idea of it just rattling around in there.
-
11-29-2009 01:54 PM #2
You can leave the band out,but keep the servo shaft in,(you won't have any braking when you downshift without the band or piston). I've built several this way,without any problems,although you make want it in for street use.
Brian
i spin the wheel and mark center, then set it back down. i have 2 pieces of smooth tin i set the tires on so i can turn side to side to check it. real easy to get off when dealing with 1/4 inch.
Toe Adjustment