Originally posted by tcodi
I'm not sure, but it's the bushing side that looks like it has a nice radius on the ID for easy insertion. I guessed that the bushing side went on the trans. side. I'll try and post a pic of it when I get home.
On a slightly different note, I got my tko 600 yesterday. The bearing retainer seems to measure around 4.68(rough estimate with some calipers) but my bell's center hole is way bigger.
I'm gonna have a sleeve pressed in at my dad's machine shop and bore it out to the correct diameter.
I found a spec sheet on the tko600 and it shows that retainer at 4.85, but there's no way I was that far off on my measurement.
Does anyone know what that dim. should be?
Also, does the bell have a clearance of .1 or something around that, or is it a tight interference fit of just a few thousanths?
p. bearn sounds right. you wonta good fit on the retainer, but should slide in and out without force.