Thread: Bad Ast Astro Van Build

Tweet

hard for me to set the pinion angle .the spring perches should be welded on last so you can set the pinion angle under the truck with engine and trans were it will be with weight on axle .i work up a price axles on center . new iron N case . big bearing pin support .solid bushing with shim pack.new yoke.limited slip setup give me two days and i PM you

Originally Posted by pat mccarthy

hard for me to set the pinion angle .the spring perches should be welded on last so you can set the pinion angle under the truck with engine and trans were it will be with weight on axle .i work up a price axles on center . new iron N case . big bearing pin support .solid bushing with shim pack.new yoke.limited slip setup give me two days and i PM you

Sounds like a plan. I will set the pinion angle before I give you the housing. That will get done probably week after next.
I haven't done ANY car shows this year due to the van build but I plan on doing back to the bricks. You planning to come down? Maybe we could hook up Saturday.

well no i have never been there .my cars have not been out this year bad year so next year i hope??? my stuff is in town stuff price of gas to run down to the brick would kill me .we can met off I75 some were or my shop what ever works for you

I'll keep you in the loop. You will know when I am ready to do the rear end. Probably be a couple of weeks.