Thread: Push rods too short?

Tweet

That is an idea that I have not had time to do as of yet but will this weekend -

I was reviewing the earlier post:

"you posted that the cam was .498 ex lift---that will be at the valve of course and with a 1.5 rocker means that cam lift will be aprox .332------ put an indicaror on the lifter and see how much lift your getting"

Just out of curiosity - if I am measuring from the pushrod side, I would look for .498 - yes?

And Pat, I have been trying to find the time to call you around 9am my time so that it's around your lunch, I just have not had the time to do that from work - seems like something always comes up and by the time that I look at the clock, it's closer to 3:00 your time... By the way, I checked out your site, very nice!

Originally Posted by JustaChevyGuy

That is an idea that I have not had time to do as of yet but will this weekend -

I was reviewing the earlier post:

"you posted that the cam was .498 ex lift---that will be at the valve of course and with a 1.5 rocker means that cam lift will be aprox .332------ put an indicaror on the lifter and see how much lift your getting"

Just out of curiosity - if I am measuring from the pushrod side, I would look for .498 - yes?

And Pat, I have been trying to find the time to call you around 9am my time so that it's around your lunch, I just have not had the time to do that from work - seems like something always comes up and by the time that I look at the clock, it's closer to 3:00 your time... By the way, I checked out your site, very nice!

thanks both sites are up still wounld of like them abit better but they do the job . show some of the many of the engine i have built and machine work i can do at my shop. well about 4:30 i start to clean up so no machines are running so i should have some time around 4.30