Thread: Push rods too short?

Tweet

do you have a small base circle cam because of the stroker????????


if its #1 ex that's bleeding down could maybe indicate that the galley plug is leaking and/or missing in the oil galley

Jeez Pat, I hope that is not the case - Just went thru that - 'll need therapy and almost do I swear...

Jerry, I have looked on everything that came with the cam and I can't find that anywhere - however researching the cam online I've seen that it's a small base circle - Comp 12-243-3 part number.

I appreciate the input, this is going to drive me nuts, that is a good direction on the galley plug-

The engine was built by local well known and experienced builder - BowTie Performance in Turner, Oregon - Ron.

I have about 2 inches of paperwork on it, so I am happy to research the direction, thanks again.

If you would like to call and chat about it, PM me and I can jet you my number-

Originally Posted by jerry clayton

do you have a small base circle cam because of the stroker????????


if its #1 ex that's bleeding down could maybe indicate that the galley plug is leaking and/or missing in the oil galley

seen this done on a chevy oil psi will be way low as well loud lifters

Originally Posted by jerry clayton

do you have a small base circle cam because of the stroker????????


if its #1 ex that's bleeding down could maybe indicate that the galley plug is leaking and/or missing in the oil galley

could be oil band in lifter body drop past lifter bore and open oil feed