Thread: Master cylinder hold off spring.

Tweet

But the 1-800 part is nowhere near as much fun as one you make yourself

While I'm going to try to use C9X's general design, I don't even have a rubber boot on mine as TCI neglected to supply one even after a couple of complaints to them plus I "forgot" to add one when I did final assembly, will try to make up one from aluminum that will fit against the end snap ring which I believe holds the innards in place.

The McMaster order will be here today, along with a Summit order so honey-do's will be put aside for a day or so

If it all works, photos will be posted for others to consider.