Thread: Trans. Leak

Tweet

Originally Posted by Itoldyouso

We just installed one of those new Lokar short transmission dipsticks on Dan's rpu and while it doesn't look like it will leak, it is a real mother when you try to pull out the dipstick. The way it works is like the quick disconnects on your shop air hose, where you pull down on the collar and it releases the chuck. But this thing is impossible to pull back, especially when installed under a car. We had to use two jewelers screwdrivers in the crack to get it to move, then we were able to pull the collar down.

I called Lokar to find out why so tough and the guy said he would bring it up to the engineers. Lokar uses this same base with their extended dipsticks, so Dan ordered the rest of the parts to move the dipstick into the engine area. That way we will never have to unclick that fitting again to check fluid.

Don

Don - when you get the new 'stick, check the fit in the tranny (assuming it's a case fill). You might want to consider different cross section o-rings if it's at all sloppy or you will be chasing another leak

This is what I wrote earlier: http://www.clubhotrod.com/forums/showthread.php?t=47879

Post 7 gives you the different o-ring sizes available

My new Hughes has a locking 'stick that I have tucked way back against the fire wall - my "special" funnel device makes sure you don't fill too quickly