Thread: Need some advice / direction to begin my project

Tweet

Thanks guys! This is the information I am looking for.

Originally Posted by ojh

...all you need to do is figure the steps to get from here to there.

Exactly! OK - so document with pictures and write down details.

Sounds like you do this often or for a living. Is there any particular spot to start? i.e. start with the floor pans, then work out to exterior I assume? Save the sub-frame until later so I can move it easier? If I don't have a grand plan I am just going to make a big mess.
Should I remove all the body panels then have it media blasted? When they media blast do they do the interior too? It is completely gutted now.

Originally Posted by pastor bubba

I did this on my daughter's truck last fall and I did not have to hunt for the appropriate screw or whatever because they were all labeled for me.

I think I saw your thread about this. Turned out nice!