Thread: A wiring question, really wish I could read a schematic

Tweet

i would like to see the plug or colors of wires you have there should be motors under the seat look at wires and color try grounding the seat try hot off the fuse box that that s hot or look to check if your 12 volts is hot ? with a tester you should fine whats going on you need to look to make sure your 12 volt feed is hot is it ? then ground the seat it should not be hard to find the hot on the seat .sure the switch is good on the seat?

Here are the pictures of the wires from the drivers side and passenger seats. I have confirmed that I have a steady 12 volts coming from the wiring harness.

I thought about a bad ground, but would it register voltage if I was too far from a good ground. Would I splice a ground in with the big black wire?

This is the passenger side. The wire nuts are not a permanent option. Wire colors are:
Black-big
Orange-big
tan
grey
orange
blue
pass wire.JPG

Driver's side wire colors are:
Black-big
Orange-big
brown
brown
green
orange
black/white stripe

driver wire.JPG